Sencore

Chip Component Test Lead (CH256) - Special shielded test leads for testing small surface mount (chip) components out-of-circuit. (optional accessory)

The CH256 is a specially designed test lead for the LC103. The special prongs on the end allow you to test clip-type or surface mount components with confidence.

The CH256 is used in place of the 39G554 test leads (supplied with the LC103) when testing chip components. The tweezers end of the CH256 allows for easy connection to chip components, while the Z-METER performs all of its tests. Follow the procedures in the instruction sheet for using the CH256, and the procedures listed in the LC103 operation manual for its operation.

The CH256 Chip Component Test Lead connects to the test lead input of the Z-METER. The tweezers tip supplies tabs for connection to small chip components. When the CH256 is used properly the Z-METER performs all tests with the same accuracy specified for the Z-METER.

The CH256 Chip Component Test Lead is equipped with a BNC connector at one end of the low capacitance coaxial cable. This connector substitutes for the BNC of the 39G554 Test Leads (supplied with the Z-METER) to connect to the test lead input on the front of the Z-METER.

Use to test chip capacitors and inductors

The CH256 Chip Component Test Lead provides two metal tabs at the end of the tweezers for making contact with the end plates of the chip component

Connects to the test lead input of the LC103 with a standard BNC connector